If you’re an all grain brewer and use a pump, the ultimate sparge arm is a must-have brewery addition. The ultimate sparge arm assembly is made completely of stainless steel and silicone and features a stainless steel thumbscrew that holds the sparge arm against the kettle, and another which allows you to move the sparge arm up or down inside the kettle to accommodate different amounts of grain. These screws are very easy to hand tighten and loosen, meaning no tools are required. Great for sparging and recirculating your mash in a RIMS or HERMS system without the potential for hot-side aeration.
Features Include:
100% stainless and silicone construction
Included 1/2″ ball valve helps regulate the flow rate
Included check ball will prevent back flow
Can adjust from the top of your kettle to 12-13 inches down into your kettle
Can be mounted on a lip that is up to 7/8″ wide
Virtually universal
Please Note – This sparge arm is designed to fit on kettles and will not fit on most thick-walled coolers.
Had a hard time deciding between this and the SS brewtech manifold. Ultimately went with this because of the movable arm and valve. Can’t say I’m disappointed. Works well.
Only logged in customers who have purchased this product may leave a review.
20 Gallon Brite Tank BME - SHIPPING INCLUDED 
Kyle (verified owner) –
Had a hard time deciding between this and the SS brewtech manifold. Ultimately went with this because of the movable arm and valve. Can’t say I’m disappointed. Works well.